KennyBug's Jaguar board build

[Kennybug]

thanks for the remind...
alright. i will remove d43 & d44. I remembered i had read andy's todo.md before; but just too happy to insert all stuffs on the board.

I have some spared polyfuse REC050 (60v 0.5a) from Jimstim. is it a good idea to use them in Jag board?

I am using USB-B socket. so the mini-usb trace fault will not affect. Besides, my PCB vendor did very bad on the Mini-USB area. Solder mask covered all pads & holes
I have checked the trace of R12 & c1 on my pcbs already.. my boards are alright.

My opto coupler also arrived. Still not sure will use them or proceed the PNP hack.

[Fred]

The only place you would want to use a polyfuse is between the 5v output and the tps on the engine. If you want to do that, ok, but check that you have good voltage on it afterward.

LOL @ soldermask issues. Care to post a close up photo for lols? :-)

Good news on c1/r12.

Don't do the pnp hack until you're ready to try the boards and need to. I may have a better solution for you by then.

Fred.

[Kennybug]

Here is it

[Fred]

Thanks! :-)

Maybe you should cut that trace anyway, just in case someone in the future tries to put a mini on it :-)

Fred.

[Kennybug]

done...
I have removed the solder mask as well LOL

[DeuceEFI]

Cool, I've been updating the TODO list about every other day as Fred and I find little things to improve.

[Kennybug]

More soldering done... WIP slowly...

[Kennybug]

passive components almost done.

[Fred]

Cool :-) The 2 leds on the vr out are experimental, use higher than specced R values till testing complete, maybe 5k?

[Kennybug]

I am so mindless that wrongly ordered 100 pcs of 470k (instead of 470R in BOM), that's why some R are missing.

Okay, will replace R9 & R10 by 5.1k.