Neat Prototyping Board Design

Post by **Fred** » Mon Feb 13, 2012 12:49 pm

Pretty cool!

http://www.elecfreaks.com/store/flower- ... p-378.html

Someone should design one of these and do a shared run of them :-)

Fred.

Post by **Fred** » Wed Sep 04, 2013 12:35 am

Article on development of the above: http://www.elecfreaks.com/2362.html

Post by **Dan** » Wed Sep 04, 2013 7:03 am

yep, i would like to do a shared run.

Will be a piece of piss to knock it up in Altium!

Who is keen for one/some/lots ?

Post by **Fred** » Wed Sep 04, 2013 12:07 pm

Me. Unsure when, not soon, but early next year I'd love to have some (several) laying around.

Would you just cover the entire surface in them edge to edge? Or? Why?

Which size break? Seeed 100x100 or 200x100 are most cost effective IIRC.

Fred.

Post by **Dan** » Wed Sep 04, 2013 1:15 pm

Probably 200x100 I would think. Rectangular seems to be a good size as opposed to square.

I would do them over the entire surface mostly, with a thin border for neatness.

Probably chuck in some 4mm diameter holes in each corner too

Post by **Fred** » Wed Sep 04, 2013 2:01 pm

Sounds fair! Make it happen. I look forward to seeing high-res photos of them on your desk and cloning the Git repo.

Post by **Dan** » Wed Sep 04, 2013 9:35 pm

DIYEFI.org Forum

Neat Prototyping Board Design

Neat Prototyping Board Design

Re: Neat Prototyping Board Design

Re: Neat Prototyping Board Design

Re: Neat Prototyping Board Design

Re: Neat Prototyping Board Design

Re: Neat Prototyping Board Design

Re: Neat Prototyping Board Design