Hentai's 1992 Mazda Miata (15th)

If you're running FreeEMS on any engine whether it be in a vehicle or not, please post about it here!
User avatar
masterkorp
LQFP112 - Up with the play
Posts: 171
Joined: Tue Jan 17, 2012 11:21 am
Location: Ponte de Lima, Portugal

Re: Hentai's 1992 Mazda Miata (15th)

Post by masterkorp »

Congrats!
User avatar
Hentai
LQFP144 - On Top Of The Game
Posts: 302
Joined: Sun Jul 18, 2010 2:35 pm

Re: Hentai's 1992 Mazda Miata (15th)

Post by Hentai »

First drive today happened, had to increase injector dead time a tad and VE, but so far good.
Then I found out when I got back into the car later my saved times weren't there so I had to do it again and hit save to flash.
I've already ran into boost with my car for sure, needs tuning.
And set around and idle with lights on\heater on max and off to watch fuel change and effect IDT changes to compenstate until it was around a steady transistion that it was close to the same values.

What I've noticed so far is the on \ off throttle transitional repsonce is good out of the box.

EMstudio "NEEDS" mass selection of cells and input one value. When you are tuning by yourself on the road its a lot esier to select a bunch of cells in one areas intiall and set a value to get it in the ball then go over the data log and check it out. Its a lot harder to select one cell and the next cell. This is something that it needs to have priority for any proper tuning, esp inital tuning.

Fred you might as well put this in the list of daily drivers, the MS2 unit isn't going back into it.
User avatar
Fred
Moderator
Posts: 15431
Joined: Tue Jan 15, 2008 2:31 pm
Location: Home sweet home!
Contact:

Re: Hentai's 1992 Mazda Miata (15th)

Post by Fred »

Updated! viewtopic.php?f=55&t=1838 :-)

Keen to get your data into the system, and work with you to get the decoder perfect. Right now your timing is likely a bit wobbly. It may be OK, if so, up to you, but, it may not be, if not, let's sort it out this weekend.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
User avatar
Hentai
LQFP144 - On Top Of The Game
Posts: 302
Joined: Sun Jul 18, 2010 2:35 pm

Re: Hentai's 1992 Mazda Miata (15th)

Post by Hentai »

Fred wrote:Updated! viewtopic.php?f=55&t=1838 :-)

Keen to get your data into the system, and work with you to get the decoder perfect. Right now your timing is likely a bit wobbly. It may be OK, if so, up to you, but, it may not be, if not, let's sort it out this weekend.
Yes I will get you the data tomorrow, forgot to do it properly today. Yeah I need to recheck timing again
Also I installed the next firmware and got it running on the LS coils, so I immeidatly turned the car off and pulled the coils out and reconnected the stock iginitor and coils, works with the stock miata iginitor and coils as well currently, thats how I drove it around, on stock iginitor and coils.
User avatar
Fred
Moderator
Posts: 15431
Joined: Tue Jan 15, 2008 2:31 pm
Location: Home sweet home!
Contact:

Re: Hentai's 1992 Mazda Miata (15th)

Post by Fred »

Cool :-) MS-spec ignition FTW/FTL :-)

No rush on data.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
User avatar
BenFenner
LQFP144 - On Top Of The Game
Posts: 360
Joined: Wed Jul 09, 2008 3:15 pm

Re: Hentai's 1992 Mazda Miata (15th)

Post by BenFenner »

Hentai wrote:EMstudio "NEEDS" mass selection of cells and input one value.
The issue for that is here: http://issues.freeems.org/view.php?id=600

I'm going to see about getting it in 0.0.1 instead of just "ASAP".
User avatar
Hentai
LQFP144 - On Top Of The Game
Posts: 302
Joined: Sun Jul 18, 2010 2:35 pm

Re: Hentai's 1992 Mazda Miata (15th)

Post by Hentai »

I plan to go and get another stock ecu from the pick and pull Friday possibily. Been cold lately so getting cold starts has been a good challenge.
User avatar
Fred
Moderator
Posts: 15431
Joined: Tue Jan 15, 2008 2:31 pm
Location: Home sweet home!
Contact:

Re: Hentai's 1992 Mazda Miata (15th)

Post by Fred »

Ask Mike or Andy how to tune your priming pulse curve in emstud. EDIT: it's normal, isn't it... nevermind... but: temp enrich curve should be obvious. default priming is utterly random, no data/experience backing it.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
User avatar
Hentai
LQFP144 - On Top Of The Game
Posts: 302
Joined: Sun Jul 18, 2010 2:35 pm

Re: Hentai's 1992 Mazda Miata (15th)

Post by Hentai »

Thats fine, I got it in area where she now fires up very fast, less then 2 engine rotations or so.
User avatar
Fred
Moderator
Posts: 15431
Joined: Tue Jan 15, 2008 2:31 pm
Location: Home sweet home!
Contact:

Re: Hentai's 1992 Mazda Miata (15th)

Post by Fred »

Good to hear :-) Decoder is good for it, even if other stuff isn't :-)
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
Post Reply