Hi guys
I am starting to order bits and pieces for my little project.
To begin with I will be needing a PCB for either Ravage or Jaguar A3. it can be with parts or without. Preferably without. Where can I get one (or 2). And by get i ofcource mean buy.
Cheers
WANTED: Ravage or Jaguar PCB
Re: WANTED: Ravage or Jaguar PCB
RavAGE is not a PCB, yet. But is very close to being one, pending some remaining testing that I and others need to conduct and compare/verify.
I would recommend Jaguar as it is a very well designed and tested hardware platform.
This obviously depends on what your requirements are though?
You can get the PCB artwork from the Jaguar GitHub repository or you can PM DeuceEFI on these forums and ask him if he has any Jaguar PCB's for sale.
I would recommend Jaguar as it is a very well designed and tested hardware platform.
This obviously depends on what your requirements are though?
You can get the PCB artwork from the Jaguar GitHub repository or you can PM DeuceEFI on these forums and ask him if he has any Jaguar PCB's for sale.
-
- LQFP112 - Up with the play
- Posts: 211
- Joined: Tue May 01, 2012 4:17 pm
- Location: Shrewsbury PA
- Contact:
Re: WANTED: Ravage or Jaguar PCB
It would only cost something like $50 to get a Jaguar PCB made from batchpcb or something, might be the way to go.
You could also get 4 made from goldenphoenix for about $100 I believe.
You could also get 4 made from goldenphoenix for about $100 I believe.
- DeuceEFI
- LQFP144 - On Top Of The Game
- Posts: 579
- Joined: Thu Feb 25, 2010 3:57 am
- Location: Gosport, IN USA
- Contact:
Re: WANTED: Ravage or Jaguar PCB
At this point unless you want to jump in feet first with a Jaguar A3 board from Kennybug, I would wait until I have all the changes done for the Jaguar A4 board which as quite a few refinements over the A3 boards.
Andy.
FreeEMS vehicle #11, 1932 Ford 5 Window Coupe with a 1996 GM 3.1L SFI V6 with DIS ignition
FreeEMS vehicle #16, 1996 Chevrolet S10 2.2L SFI I4 with DIS ignition
Owner of http://www.coolefi.com
FreeEMS vehicle #11, 1932 Ford 5 Window Coupe with a 1996 GM 3.1L SFI V6 with DIS ignition
FreeEMS vehicle #16, 1996 Chevrolet S10 2.2L SFI I4 with DIS ignition
Owner of http://www.coolefi.com
Re: WANTED: Ravage or Jaguar PCB
Ok - not a problem - I can wait, but it would be nice if you give me a rough estimate when Jaguar A4 will be around? I am watching progress report on A4 for quite some time and I am willing to wait for it if its going to come in .......lets say half a year.
Re: WANTED: Ravage or Jaguar PCB
Andy is working pretty much on it daily, so it would be a safe assumption (i think) that A4 would be ready within the next 6 months.
RavAGE spin 1 will likely be released within that timeframe too!
RavAGE spin 1 will likely be released within that timeframe too!