Page 1 of 1
Interface board
Posted: Mon Sep 20, 2010 4:10 pm
by davecramer
I'm sure there's a thread here that describes the interface board(s) but I can't find it.
Is there an interface board designed ?
Dave
Re: Interface board
Posted: Mon Sep 20, 2010 10:11 pm
by Fred
What exactly do you mean by that?
Re: Interface board
Posted: Mon Sep 20, 2010 11:17 pm
by davecramer
What do you use to actually drive the engine components ?
Re: Interface board
Posted: Tue Sep 21, 2010 12:33 am
by jharvey
Sounds like the connector card theory is what your inquiring about. The stack of FreeEMS 1.0 intends to use a connector card, which has not been designed yet. I drew most of FreeEMS 1.0 and my goals are for a small engine, so I plan to run a harness direct to the 1.0 board. However those that want a connector for easy removal/replacement, ect they would want a connector card, which will need to be designed per application. I believe that FreeEMS for Argentina also plans for a connector card.
Re: Interface board
Posted: Tue Sep 21, 2010 1:18 pm
by Fred
There are several designs in the works, but there are some hold ups with them, due to me etc. And Jared, I don't think he means connector card as you mean it, no.
Fred.