This may be obvious, but I thought I'd point it out anyway. If you ground your transistorless LEDs you will get the same phase as I get with my transistors grounding the LEDs and the positive feed always on. I just realised this watching the "user led" and a pwm led flashing in sync together, one driven directly by the CPU, the other by a transistor...
If you do this, it means no code mods to get the same behaviour as me with less soldering and less components.
Admin.
Sean's FreeEMS Proto Hardware
Re: Sean's FreeEMS Proto Hardware
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
- SleepyKeys
- LQFP144 - On Top Of The Game
- Posts: 549
- Joined: Mon Feb 11, 2008 10:52 pm
- Location: Arizona
- Contact:
Re: Sean's FreeEMS Proto Hardware
I was thinking about doing that actually. What program do you use to draw electrical diagrams? We should probably start getting some diagrams together as we work along.
You snooze, you lose!
Re: Sean's FreeEMS Proto Hardware
I've played with KiCad which is the only decent open source one available as far as I know. Eagle is free to use up to 100 x 80, and therefore fine for drawing schematics for testing etc, but not fine for final designs as it rules out commercial production too...
Hooking up an LED hardly needs a diagram though does it? :-)
Admin.
Hooking up an LED hardly needs a diagram though does it? :-)
Admin.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
- SleepyKeys
- LQFP144 - On Top Of The Game
- Posts: 549
- Joined: Mon Feb 11, 2008 10:52 pm
- Location: Arizona
- Contact:
Re: Sean's FreeEMS Proto Hardware
Admin wrote:I've played with KiCad which is the only decent open source one available as far as I know. Eagle is free to use up to 100 x 80, and therefore fine for drawing schematics for testing etc, but not fine for final designs as it rules out commercial production too...
Hooking up an LED hardly needs a diagram though does it?
Admin.
Haha, no but it would be nice to have a schematic for "Opti-spark" interfacing, ya know what I mean. Stuff to piece together when we design the mb.
You snooze, you lose!