DIYEFI.org Forum
http://forum.diyefi.org/

TPS Resistance Survey
http://forum.diyefi.org/viewtopic.php?f=9&t=1338
Page 2 of 2

Author:  DaWaN [ Sun Oct 02, 2011 11:55 am ]
Post subject:  Re: TPS Resistance Survey

For Honda's it seems to be around 6kOhms, will check it on my own car later on!

Author:  Fred [ Tue Feb 04, 2014 8:33 am ]
Post subject:  Re: TPS Resistance Survey

For an ancient turbo Starion TBI TPS as soon to be used on the mighty hotel, it's 4.7k end to end. This old-fashioned unit goes end to end, too, so default TPS is pretty much right for this. Most modern TPSes have their limits inset into the voltage range for error detection purposes. It may still show up like that on the vehicle, however on the bench it's full-range.

Author:  HD13 [ Tue Feb 04, 2014 6:26 pm ]
Post subject:  Re: TPS Resistance Survey

Using this one its between the first and second ITB.
Its universal, for D shaped axel.
If someone is interested i will dig up the specs.

Sensor is Vishay 971-0001 is also available whit connector (-0002).
See 971. pdf

Fits D-shaped 8mm axle.
Kawasaki GPZ1100 B2 throttle bodies.

Attachments:
971.pdf [62.1 KiB]
Downloaded 208 times
DSC_9912.JPG
DSC_9912.JPG [ 3.22 MiB | Viewed 3650 times ]

Author:  Fred [ Tue Feb 04, 2014 8:51 pm ]
Post subject:  Re: TPS Resistance Survey

Yes, please edit the post with what it's from (brand, model, engine, year) and the end-to-end resistance. Let's keep the signal to noise ratio as high as possible (no extra unnecessary posts).

Author:  volvoguy [ Mon May 19, 2014 11:33 am ]
Post subject:  Re: TPS Resistance Survey

Loads of Rover and Ford part numbers for this, MJC100021, JZX3491, findpart.org lists loads of analogues. According to this page it's 4kOhm +/- 20%, I measured 200Ohm to 3.8kOhm over the ~125 degree sweep. It uses the standard 8mm diameter D-shaped spindle. The ~4.2mm diameter mounting holes measure 32mm c/c (fits the Volvo B230 throttle body better than the original throttle switch does) and they're surrounded by thick enough plastic that they could be cut into arcs to allow for adjustment (not necessary on B230).
Image

Author:  Ruffcut [ Tue May 20, 2014 10:54 pm ]
Post subject:  Re: TPS Resistance Survey

Hi,

Rover V8 using hot wire Lucas 14CUX system is 5kohms.

for reference:- http://en.wikipedia.org/wiki/Lucas_14CUX

Hope this helps

Peter

Page 2 of 2 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/