Using Chinese "JB16" TBDMs with USBDM

From DIY contraptions to sophisticated FreeEMS-specific designs! Plus general hardware development!
User avatar
Fred
Moderator
Posts: 15431
Joined: Tue Jan 15, 2008 2:31 pm
Location: Home sweet home!
Contact:

Re: Using Chinese "JB16" TBDMs with USBDM

Post by Fred »

Enviado! Certificada, tambien! :-p PS, su codigo postal no existen! Yo creo que mucho de Galicia no existen! :-p
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
User avatar
AiToR51
QFP80 - Contributor
Posts: 80
Joined: Sun Aug 21, 2011 6:26 pm
Location: Spain

Re: Using Chinese "JB16" TBDMs with USBDM

Post by AiToR51 »

thanks. I should live in a phantom place. First time I hear that of my postal code.
Sierra XR4i 2.0T
efiuser
TO92 - Vaguely active
Posts: 1
Joined: Wed Mar 16, 2016 8:35 pm

Re: Using Chinese "JB16" TBDMs with USBDM

Post by efiuser »

Hi Fred.

It's possible to have the Serial Monitor source code ?

I would appreciate you greatly.

Thanks in advance,
User avatar
Fred
Moderator
Posts: 15431
Joined: Tue Jan 15, 2008 2:31 pm
Location: Home sweet home!
Contact:

Re: Using Chinese "JB16" TBDMs with USBDM

Post by Fred »

It's all over the internet, no need to ask me for it. What's your particular application?
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
jawier130
TO220 - Visibile
Posts: 6
Joined: Fri Feb 27, 2015 9:47 am

Re: Using Chinese "JB16" TBDMs with USBDM

Post by jawier130 »

Hi, i was testing the bootloader monitor from freeems and the AN3275.
The firs work OK but AN3275 not, also, i suppose that it are mod to use the boot jumper.
Is it not possible get the source code to the monitor?, or at least the protocol commands to use it?
Post Reply