DIYEFI.org Forum

If I had a wish for FreeEMS, I'd like to have the ability to map out the high/low slope of an injector .. like on Ford cals (look at ford performace website). It doesn't need to follow the same form .. but somehow to map the 'squigglies' on either end of the flow data on this injector:

http://www.injectordynamics.com/dynamic ... ation.html

Every single injector I've ever mapped out on my flowbench exibit these same characteristics to varying extent. I know that most people will never map out their injectors to this degree, but to have the ability to handle it would be a nice to have feature.

Then there's characterization over voltage.

yep - which is more critical to low-impedence folks who use ballast R's

I know a few low-impedance folks who are ballast. :rimshot