Injector Characterization

Official FreeEMS vanilla firmware development, the heart and soul of the system!
Post Reply
User avatar
EssEss
LQFP112 - Up with the play
Posts: 244
Joined: Thu Sep 10, 2009 9:23 am
Location: Dayton, OH

Injector Characterization

Post by EssEss »

If I had a wish for FreeEMS, I'd like to have the ability to map out the high/low slope of an injector .. like on Ford cals (look at ford performace website). It doesn't need to follow the same form .. but somehow to map the 'squigglies' on either end of the flow data on this injector:

http://www.injectordynamics.com/dynamic ... ation.html

Every single injector I've ever mapped out on my flowbench exibit these same characteristics to varying extent. I know that most people will never map out their injectors to this degree, but to have the ability to handle it would be a nice to have feature.
MotoFab
1N4001 - Signed up
Posts: 307
Joined: Thu May 29, 2008 1:23 am
Location: Long Beach CA

Re: Injector Characterization

Post by MotoFab »

Then there's characterization over voltage.
User avatar
EssEss
LQFP112 - Up with the play
Posts: 244
Joined: Thu Sep 10, 2009 9:23 am
Location: Dayton, OH

Re: Injector Characterization

Post by EssEss »

yep - which is more critical to low-impedence folks who use ballast R's
MotoFab
1N4001 - Signed up
Posts: 307
Joined: Thu May 29, 2008 1:23 am
Location: Long Beach CA

Re: Injector Characterization

Post by MotoFab »

I know a few low-impedance folks who are ballast. :rimshot
Post Reply