XGATE and eTPU info from Freescale

Official FreeEMS vanilla firmware development, the heart and soul of the system!
Post Reply
MotoFab
1N4001 - Signed up
Posts: 307
Joined: Thu May 29, 2008 1:23 am
Location: Long Beach CA

XGATE and eTPU info from Freescale

Post by MotoFab »

Got this in a newsletter, thought some here might be interested.

This is a short online XGATE primer, part 1 of 2. There's a link to part 2 on the right side nav bar.
http://www.freescale.com/webapp/sps/sit ... T_PRGMMING

This is a 3 day course on the eTPU offered in Novi, Michigan.
Programming the eTPU in C
https://getregisterednow.com/Training/R ... Novi,%20MI

- Jim
User avatar
Fred
Moderator
Posts: 15431
Joined: Tue Jan 15, 2008 2:31 pm
Location: Home sweet home!
Contact:

Re: XGATE and eTPU info from Freescale

Post by Fred »

Well, I finally got around to watching the xgate stuff and it is right on time. We'll be implementing xgate routines over the next few months to support the full goals of this system and these things will come in handy. It's pretty basic stuff, but easy to get wrong too. YT links :

Part 1 : http://www.youtube.com/v/HIefwdVQnjg

Part 2 : http://www.youtube.com/v/oWMq6MTEZsw

Thanks Jim! :-)

Fred.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
Post Reply