Re: How to compile source code for FreeEMS
Posted: Sun Aug 31, 2014 8:23 pm
:-)
TRUE DIY engine management discussion forum
http://forum.diyefi.org/
This means that two cylinders are at TDC at 0 degrees and then the other two are at TDC at 90 degrees of the crank. If this isn't correct then the angles need to be changed.whizzo944 wrote:anglesOfTDC: {ANGLE(0), ANGLE(90), ANGLE(0), ANGLE(90)},
the number of elements in this array should be equal to the number of anglesOfTDC, so there should be 4 elements, ie:whizzo944 wrote:outputEventPinNumbers: {0,1,2,3,4,5,4,5}, // Wasted Spark and semi-sequential
Code: Select all
outputEventPinNumbers: {0,1,2,3}, // Wasted Spark and semi-sequential injection
this is correct based on the previous array configurations above.whizzo944 wrote:schedulingConfigurationBits: {0,0,1,1}, // First two ignition, last two fuel
This should be 0.00 until you measure the actual angle using a timing light while cranking without the injectors connected. You don't want the engine to try to run until you are sure about this value.whizzo944 wrote:decoderEngineOffset: ANGLE(70.00), //
These look correct based on the above settings.whizzo944 wrote:numberOfConfiguredOutputEvents: 4, // Migrated to new way
numberOfInjectionsPerEngineCycle: 2 // Used to be batch, dead time being wrong could have affected AFRs