DIYEFI.org Forum
http://forum.diyefi.org/

Programing question.
http://forum.diyefi.org/viewtopic.php?f=8&t=2453
Page 1 of 1

Author:  jknightandkarr [ Mon May 26, 2014 8:11 am ]
Post subject:  Programing question.

Is the microcontroller for the FreeEMS and the Motorola 68HC11 happen to the same or atleast similar programing languages? I have the GM 89 5.7 TBI ecm main code and the 89 5.0 TBI calmap data and trying to decode the ecm main code and while its in the language, I don't know the language so its kinda hard to understand what I'm looking at exactly. Or if anyone just happens to already know the details of the gm tbi setup esp the math, details of the ecm board I/O details, since all IC chips been given delco part no's, any help would be appreciated.

Joe

Author:  Fred [ Mon May 26, 2014 11:35 am ]
Post subject:  Re: Programing question.

Similar instruction set, but if you're reverse engineering, you're looking at assembly, which FreeEMS mostly does not use.

Fred.

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/