Manual Injector PWM control
Posted: Wed Apr 10, 2013 10:31 pm
My engine will operate from sea level to altitudes exceeding 20,000 feet, where the air is much less dense. Also, during cruise it is often very advantageous to lean the mixture to well below the 14.7:1 to extend the range of the flight. The air is so thin at high altitudes, that it often takes 60 to 70% of the power to get the same speed as at lower levels. Also, during takeoff, we often run quite rich to help cool the engine until we get more airflow.
So, I would like to see if I can install a simple POT for this manual adjustment. Center on the pot will be "0", the low range will be lean, the high will be rich.
Which file would be the best for this?
So, I would like to see if I can install a simple POT for this manual adjustment. Center on the pot will be "0", the low range will be lean, the high will be rich.
Which file would be the best for this?