Fred requested that I post this here.
So typically the best way to do firmware/software dev is thus:
http://stuff.fredcooke.com/usb.powered.ta.card.jpg
Fred recommends buying one of these: http://www.parallax.com/tabid/768/Produ ... fault.aspx
and modifying it to add external power
However, if you have more money than sense, I found one of these: http://www.technologicalarts.ca/catalog ... cts_id=458
Comes pre-modded with the power wire. Just something I thought was useful.
Useful USB to Serial for firmware/software development
-
- LQFP112 - Up with the play
- Posts: 211
- Joined: Tue May 01, 2012 4:17 pm
- Location: Shrewsbury PA
- Contact:
Re: Useful USB to Serial for firmware/software development
Cheers :-)
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!