AiToR51's Jaguar 0.7 alpha

Andy's GM DIS centric hardware design! Also works as a fuel controller for EDIS and distributor applications.
Post Reply
User avatar
AiToR51
QFP80 - Contributor
Posts: 80
Joined: Sun Aug 21, 2011 6:26 pm
Location: Spain

AiToR51's Jaguar 0.7 alpha

Post by AiToR51 »

My build has to be compatible with 3 engines:

Ford 2.0 DOHC 8v:
- 36-1 VR sensor + 4 inj high impedance (fired in 2 pairs), wasted spark with 2 coils.

Very easy, I've run it with a DIY FreeEMS

Ford 2.9 24v V6 cosworth (BOB):
- Very similar to the previous one. 36-1 VR sensor, 6 inj high impedance (as stock is sequential, now, I've it in 2 pairs banks with a M$1), wasted spark 3 coils.

Ford 2.0 16v cosworth (YB):
not as easy as the previous ones. I think it has a 4 dent pulley 90º spaced + distributor phase sensor + low impedance injectors as std

Image


but I don't care a lot about the last engine. For the moment it will be ok with stock ecu.I don't have plans of running it with extreme modifications.


so in summary, it will
Sierra XR4i 2.0T
User avatar
Fred
Moderator
Posts: 15431
Joined: Tue Jan 15, 2008 2:31 pm
Location: Home sweet home!
Contact:

Re: AiToR51's Jaguar 0.7 alpha

Post by Fred »

I can whip up a decoder for your last engine very easily. Let me know when it's needed and I'll do just that. Is it hall or VR, though? This will cause you minor pain setting up the Jag if different.

As for low-z, I HIGHLY recommend using the http://jbperf.com 2.0.1 low-z driver box. It's very convenient and pretty inexpensive. If you install it on that car, then then Jag can remain high-z style and it'll work equally with all engines. Here's mine as installed in the hotel: https://twitter.com/FreeEMS/status/474866848123469824
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
User avatar
AiToR51
QFP80 - Contributor
Posts: 80
Joined: Sun Aug 21, 2011 6:26 pm
Location: Spain

Re: AiToR51's Jaguar 0.7 alpha

Post by AiToR51 »

ok, is good to know :)

both sensors (crank and distributor are supposed to be VR, so is easy, I will start building it as for VR sensor
Sierra XR4i 2.0T
User avatar
AiToR51
QFP80 - Contributor
Posts: 80
Joined: Sun Aug 21, 2011 6:26 pm
Location: Spain

Re: AiToR51's Jaguar 0.7 alpha

Post by AiToR51 »

a pic

Image
Sierra XR4i 2.0T
Post Reply