I have found out that Freescale discontinued the SOP-8 400kPa pressure sensors, they only manufacture this sensor in the SSOP-8 (smaller package). Since the Jaguar 0.4-alpha through the 0.7-alpha PCBs only have the SOP-8 pads I have designed an adapter board.
This board will solder in place of the SOP-8 sensor and allow you to solder the SSOP-8 sensor on top of the adapter board.
I have posted the design in my github repository at https://github.com/DeuceEFI/MAP-Adapter
I have included KiCAD 3D renderings of both sides of the adapter board:
Top SSOP-8 side:
Bottom SOP-8 side:
Cheers,
SSOP-8 to SOP-8 Adapter boards
- DeuceEFI
- LQFP144 - On Top Of The Game
- Posts: 578
- Joined: Thu Feb 25, 2010 3:57 am
- Location: Gosport, IN USA
- Contact:
SSOP-8 to SOP-8 Adapter boards
Andy.
FreeEMS vehicle #11, 1932 Ford 5 Window Coupe with a 1996 GM 3.1L SFI V6 with DIS ignition
FreeEMS vehicle #16, 1996 Chevrolet S10 2.2L SFI I4 with DIS ignition
Owner of http://www.coolefi.com
FreeEMS vehicle #11, 1932 Ford 5 Window Coupe with a 1996 GM 3.1L SFI V6 with DIS ignition
FreeEMS vehicle #16, 1996 Chevrolet S10 2.2L SFI I4 with DIS ignition
Owner of http://www.coolefi.com
Re: SSOP-8 to SOP-8 Adapter boards
Good work, Andy! :-)
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!