DIYEFI.org Forum
http://forum.diyefi.org/

Impregacy's Jaguar 0.6 build
http://forum.diyefi.org/viewtopic.php?f=67&t=2426
Page 5 of 5

Author:  Impregacy [ Fri Sep 05, 2014 3:11 am ]
Post subject:  Re: Impregacy's Jaguar 0.6 build

Thanks Fred,

The V angle for the engine is 90d, does anyone's engine experience tell them what the TDC angle should be?

In other news. I worked some more on the proper enclosure. Made an end plate and notched the case to accept the TE connector that Andy spec'd out in his BOM. I'm too lazy to make an adapter board, but I noticed that the TE crimp plugs fit nicely over the connector pins, so I'm thinking to jumper to the board locations that way (like the wire I mocked up in the last picture). I'm a little concerened that they could shake off though.

Image

Image

Image

Author:  Impregacy [ Tue Sep 16, 2014 4:48 am ]
Post subject:  Re: Impregacy's Jaguar 0.6 build

Was able to do internal wiring tonight:

Image

Author:  Fred [ Sun Sep 28, 2014 5:16 am ]
Post subject:  Re: Impregacy's Jaguar 0.6 build

viewtopic.php?f=55&t=2523 < In use on #33 :-D

Page 5 of 5 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/