Page 5 of 5

Re: Impregacy's Jaguar 0.6 build

Posted: Fri Sep 05, 2014 3:11 am
by Impregacy
Thanks Fred,

The V angle for the engine is 90d, does anyone's engine experience tell them what the TDC angle should be?

In other news. I worked some more on the proper enclosure. Made an end plate and notched the case to accept the TE connector that Andy spec'd out in his BOM. I'm too lazy to make an adapter board, but I noticed that the TE crimp plugs fit nicely over the connector pins, so I'm thinking to jumper to the board locations that way (like the wire I mocked up in the last picture). I'm a little concerened that they could shake off though.

Image

Image

Image

Re: Impregacy's Jaguar 0.6 build

Posted: Tue Sep 16, 2014 4:48 am
by Impregacy
Was able to do internal wiring tonight:

Image

Re: Impregacy's Jaguar 0.6 build

Posted: Sun Sep 28, 2014 5:16 am
by Fred
viewtopic.php?f=55&t=2523 < In use on #33 :-D