Impregacy's Jaguar 0.6 build

Andy's GM DIS centric hardware design! Also works as a fuel controller for EDIS and distributor applications.
Impregacy
QFP80 - Contributor
Posts: 67
Joined: Fri Feb 26, 2010 12:15 am

Re: Impregacy's Jaguar 0.6 build

Post by Impregacy »

Thanks Fred,

The V angle for the engine is 90d, does anyone's engine experience tell them what the TDC angle should be?

In other news. I worked some more on the proper enclosure. Made an end plate and notched the case to accept the TE connector that Andy spec'd out in his BOM. I'm too lazy to make an adapter board, but I noticed that the TE crimp plugs fit nicely over the connector pins, so I'm thinking to jumper to the board locations that way (like the wire I mocked up in the last picture). I'm a little concerened that they could shake off though.

Image

Image

Image
Impregacy
QFP80 - Contributor
Posts: 67
Joined: Fri Feb 26, 2010 12:15 am

Re: Impregacy's Jaguar 0.6 build

Post by Impregacy »

Was able to do internal wiring tonight:

Image
User avatar
Fred
Moderator
Posts: 15431
Joined: Tue Jan 15, 2008 2:31 pm
Location: Home sweet home!
Contact:

Re: Impregacy's Jaguar 0.6 build

Post by Fred »

viewtopic.php?f=55&t=2523 < In use on #33 :-D
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
Post Reply