Masterkorp's Jaguar 0.4 alpha build.

Andy's GM DIS centric hardware design! Also works as a fuel controller for EDIS and distributor applications.
User avatar
masterkorp
LQFP112 - Up with the play
Posts: 171
Joined: Tue Jan 17, 2012 11:21 am
Location: Ponte de Lima, Portugal

Re: Masterkorp's Jaguar 0.4 alpha build.

Post by masterkorp »

Hello again,

Ignition Setup

So, my Ignition setup should be more or less like this:

Image

Can you guys confirm?

Regards,
User avatar
Fred
Moderator
Posts: 15431
Joined: Tue Jan 15, 2008 2:31 pm
Location: Home sweet home!
Contact:

Re: Masterkorp's Jaguar 0.4 alpha build.

Post by Fred »

Yes, except that ideally you'd ditch the on-board current limit resistors, and provide one each inline to each of your ignitor inputs to *guarantee* they get switched correctly. Corbon did it this way in his DIY style jaguar build. His motherboard has 6 high power resistor locations, and is fed from the Jaguar with resistors removed.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
User avatar
masterkorp
LQFP112 - Up with the play
Posts: 171
Joined: Tue Jan 17, 2012 11:21 am
Location: Ponte de Lima, Portugal

Re: Masterkorp's Jaguar 0.4 alpha build.

Post by masterkorp »

Updated Igntion Setup

Here is the updated diagram:
Image

Questions/doubts:
  • The resistors are the same Yageo FMP200FRF52-160R , that you can get on DigiKey?
  • Any tips on desoldering R91, R92 and R100?
  • Is wire be enough to reconnect ?
Injection Setup
  • Any tips on soldering the Ohm jumpers?
Regards,
User avatar
Fred
Moderator
Posts: 15431
Joined: Tue Jan 15, 2008 2:31 pm
Location: Home sweet home!
Contact:

Re: Masterkorp's Jaguar 0.4 alpha build.

Post by Fred »

In order:

* Yes
* Cut the long leg at the top, heat the bottom of the other one while GENTLY pulling (strong pulling will destroy the PCB just prior to full melting) and the resistor body will come away. You can then use long leg you cut off at the top to bend over and poke down through the hole forming a bridge. Or any other scheme that works for you and is physically reliable.
* Covered above.

Tip: Position one well, hold it still, and solder the inner end of it. Repeat, soldering the far most exposed edge carefully with minimal solder, nearly dry. Repeat repeat. Once all have one end secured and are aligned well, float the remaining joints starting with the first one, and then reflowing the rest as you flow the dry next to them.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
Post Reply