Mikes Jag build, Serial #3 (Comments welcome)

Andy's GM DIS centric hardware design! Also works as a fuel controller for EDIS and distributor applications.
User avatar
DeuceEFI
LQFP144 - On Top Of The Game
Posts: 578
Joined: Thu Feb 25, 2010 3:57 am
Location: Gosport, IN USA
Contact:

Re: Mikes Jag build, Serial #3 (Comments welcome)

Post by DeuceEFI »

malcom2073 and I have been working in the user channel on IRC as well this evening to get his configuration closer to being ready to run his engine. More progress tomorrow :-)
malcom2073
LQFP112 - Up with the play
Posts: 211
Joined: Tue May 01, 2012 4:17 pm
Location: Shrewsbury PA
Contact:

Re: Mikes Jag build, Serial #3 (Comments welcome)

Post by malcom2073 »

DeuceEFI wrote:malcom2073 and I have been working in the user channel on IRC as well this evening to get his configuration closer to being ready to run his engine. More progress tomorrow :-)
Yep! The help is very much appreciated. I need to find my jimstim or get everything hooked up on the bench with the TA card to simulate rpm input, so I don't have to keep going out to the car to test this decoder. It's just 0-5V pulses, I could probably write a 5 minute program with the arduino to simulate that if I can't find my other hardware laying around :P
Post Reply