DIYEFI.org Forum

This thread will keep track of the YouTube URLs for videos of my Jaguar A3 build.

First video: http://www.youtube.com/watch?v=hzqWHjUgNrM

More to come

I'm not sure if you can fix it using the YT UI, but you might have to reupload that and change the link, because it's all on its side and very hard to see. :-) What are you trying to show exactly, anyway?

Appearently when I take video in landscape mode on my iPhone it saves it as portrait mode. I have edited the video through the YT GUI and it should be corrected shortly as soon as it is done processing.

This was my first ever video upload to YT and it shows my first Jaguar board running the freeems-vanilla benchtest firmware and that MTX is communicating with the firmware. Nothing major, just a test that I can upload video and wanted my first video to be of Fred's firmware running on my hardware

More videos to come in the near future...

Video showing completed Jaguar A3 board going through the fuel pump prime cycle then running the bench test from MegaTunix.

http://youtu.be/YVrYxXyp6b4

You should have slowed down the rate for the video and made it run a bit longer too :-) Looks cool! Nice to see an integrated purpose built board actually working as designed LOL... :-)

Fly around Jaguar with some of the case included at the end.

http://youtu.be/i2_S9ULj0Ks

First start with Jaguar A3 board running FreeEMS firmware on my GM 3.1L V6 using the 3x Tach signal from the DIS module and the 1x Cam position Hall Effect sensor as RPM/Position inputs.
http://youtu.be/rCacE4CE4R8

Pan around the engine after starting it up:
http://youtu.be/MM2kjRFz0No

Video of the Deuce starting up in the driveway and driving around:

http://www.youtube.com/watch?v=QSgk9IjBvWA&feature=plcp