DIYEFI.org Forum
http://forum.diyefi.org/

Using better design for TPIC8101 is not ok !
http://forum.diyefi.org/viewtopic.php?f=6&t=2519
Page 1 of 1

Author:  ruzki [ Thu Sep 11, 2014 8:56 pm ]
Post subject:  Using better design for TPIC8101 is not ok !

http://www.msextra.com/forums/viewtopic ... 67&t=55277

:roll:

Author:  molak [ Wed Sep 17, 2014 6:17 am ]
Post subject:  Re: Using better design for TPIC8101 is not ok !

nothing is ok in the MS world...

Author:  AiToR51 [ Wed Sep 17, 2014 7:59 pm ]
Post subject:  Re: Using better design for TPIC8101 is not ok !

nothing new..

Author:  Fred [ Wed Sep 17, 2014 9:27 pm ]
Post subject:  Re: Using better design for TPIC8101 is not ok !

http://m.youtube.com/watch?v=u5CVsCnxyXg

It's behaviour exactly like this that you can thank for the existence of DIYEFI.org and the FreeEMS project!

Author:  reanimotion [ Thu Sep 18, 2014 1:15 am ]
Post subject:  Re: Using better design for TPIC8101 is not ok !

I think it's even sillier than that.

Correct me if I'm wrong, but the OP in the thread is wanting to use the knock module on another project or system not bring something to the MS3
so there would be no dilution to the MS3 environment, just at least one extra sale of the JSM module :roll:

So...

Author:  Fred [ Thu Sep 18, 2014 5:54 am ]
Post subject:  Re: Using better design for TPIC8101 is not ok !

Ha! You're right! Shows you how far they'll go to protect their core business! :-) One sale doesn't matter, provided that we can stop the pirates! :-D

Author:  russian [ Thu Oct 02, 2014 8:44 pm ]
Post subject:  Re: Using better design for TPIC8101 is not ok !

Image

I know this board - it's available at https://svn.code.sf.net/p/rusefi/code/trunk/hardware/hip9011/ :)

Author:  DonTZ125 [ Wed Oct 08, 2014 1:10 am ]
Post subject:  Re: Using better design for TPIC8101 is not ok !

Forgive my ignorance - is the HIP9011 circuit shown above useable without the SO/SI pins? Can they be eliminated from the circuit? The datasheet says they have internal pull-ups, but I just had a graphic demonstration on a prototype of my own on why you can't always trust such beasts.

Is the HIP9011 / TPIC8101 etc useable 'out of the box', or does it require some programming via the SO/SI pins, or other means?

Author:  DonTZ125 [ Mon Oct 13, 2014 4:03 am ]
Post subject:  Re: Using better design for TPIC8101 is not ok !

Apparently not! :)

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/