Page 2 of 2

Re: Beginner needs some advice

Posted: Mon Jul 16, 2018 10:10 pm
by gyro
SMD is outside my skill set, I don't have the gear and have trouble seeing tiny pins now.
Where can I find a datasheet on the processor? General search turns up everything but.

Re: Beginner needs some advice

Posted: Tue Jul 17, 2018 12:59 pm
by Fred
https://www.nxp.com/products/processors ... mcus:S12XD?
https://www.nxp.com/docs/en/data-sheet/ ... 12RMV2.pdf

Agreed, searching didn't do me much good, either. But it wasn't too hard to find on nxp.com so there you go.

http://coolefi.com/products/ecu/15-cool ... c-ecu.html < Andy's commercial product. I can't vouch for it, yet, but I should change that ASAP.

Re: Beginner needs some advice

Posted: Thu Apr 15, 2021 6:28 pm
by miamitraffic
miamitraffic wrote:It does. Im looking forward to start the process around November this year.
Hey guys, im back at it... altough there were some delays, i finally equipped the engine with suitable BMW K1200GT ITBs. Want to start with electronics soon.

See you.

Re: Beginner needs some advice

Posted: Fri Apr 16, 2021 6:38 am
by Fred
Oh hi! Necro thread is standard around here these days :-D You'll fit right in.