Maserati Biturbo project

For people running FreeEMS to discuss it and ask any questions about using and adjusting it.
Post Reply
cucumber
TO220 - Visibile
Posts: 6
Joined: Mon Nov 21, 2011 11:20 am

Maserati Biturbo project

Post by cucumber »

Good morning, everyone.

It has long been watching this forum and I'm starting to build their own engine management system.

Recently a reason why it is worth to finally take charge of this project - I bought a '84 Maserati Biturbo 2500 with carburetor.
As the name suggests, the car has two separate turbochargers on both sides of V6 engine.

If time permits, I would install FreeEMS there.
Thus, from this place I would like to ask for your support.
For their part, I offer designing new hardware for your project, and testing its functionality, developing FreeEMS.
If this project succeeds, it could be a great advertising around FreeEMS.

Ultimately I would expect from ECU (sometime?):
-V6/V8 turbocharged engine control
-operating turbo's solenoid valves
-knock-sensor support
-fuel consumption display
-good solution to idle maintaining (I'm not sure if MAP is enough)
-self-learning based on the signal from WBO2 probe

I hereby would like to ask you to refer me to the key topics / posts that I should read to get familiar with building own FreeEMS.
malcom2073
LQFP112 - Up with the play
Posts: 211
Joined: Tue May 01, 2012 4:17 pm
Location: Shrewsbury PA
Contact:

Re: Maserati Biturbo project

Post by malcom2073 »

Hello, and welcome!!

First thing would probably be the current status of FreeEMS: viewtopic.php?f=41&t=1699

This should give you a top level idea of where the project is at in terms of maturity.

The currently supported configurations: viewtopic.php?f=54&t=1084

I'll post more with later, or hopefully someone else will chime in.
cucumber
TO220 - Visibile
Posts: 6
Joined: Mon Nov 21, 2011 11:20 am

Re: Maserati Biturbo project

Post by cucumber »

For now, thank you, but I'm waiting for further information.
Post Reply