My ECU build thread for Citroen ZX 1.6 gasoline
Posted: Mon Dec 17, 2012 4:33 pm
EMStudio is nice and easy to use, I use it to debug my A/D circuite and the MAP works fine and so is my MAX9924. My question is how to stimulate injectors
my MAP
under normal ambient temperature
Drain it and see how low it can reach
This is the pressure my Buick Regal's GM 3.1 can reach at idle
Use a function generator to stimulate tach input
I can see the count increase again and again from 0-255
Then I populate vnp10n07, but the leds don't blink but keep light on
I use this firmware so far
any way, can I use 60-2 decoder to run my engine?
my MAP
under normal ambient temperature
Drain it and see how low it can reach
This is the pressure my Buick Regal's GM 3.1 can reach at idle
Use a function generator to stimulate tach input
I can see the count increase again and again from 0-255
Then I populate vnp10n07, but the leds don't blink but keep light on
I use this firmware so far
any way, can I use 60-2 decoder to run my engine?