DIYEFI.org Forum

I seem to recall Fred posted a map that noted what techart pin was planned for what port/pin. I can't seem to find that picture. Do you remember where it is Fred?

Edit:
oops, what am I doing posting this here. Any how, do you remember were that is?
/Edit:

This is available in every firmware release (I think) as a spreadsheet file in the docs directory. I know I've seen it somewhere else but can't remember at this time.

Jean

I'm scratching around in the firmware now, still haven't stumbled on it yet. I know it's there. About to call it a night. Perhaps I'll have better luck in the morn.

jbelanger wrote:This is available in every firmware release (you know!) as a spreadsheet file in the docs directory.

Fixed it for ya ;-) Yes, just like Jean says, in the docs directory called XDP512.....pinout.....ods or similar. I think I emailed you an xls copy too didn't I?

Fred.

So I found what I was talking out here

http://www.diyefi.org/forum/viewtopic.php?f=9&t=336

Looks like it's a partical snap shot, however. So I guess I'm going to have to install open-office.