I seem to recall Fred posted a map that noted what techart pin was planned for what port/pin. I can't seem to find that picture. Do you remember where it is Fred?
Edit:
oops, what am I doing posting this here. Any how, do you remember were that is?
/Edit:
ECU pinout?
Re: ECU pinout?
This is available in every firmware release (I think) as a spreadsheet file in the docs directory. I know I've seen it somewhere else but can't remember at this time.
Jean
Jean
Re: ECU pinout?
I'm scratching around in the firmware now, still haven't stumbled on it yet. I know it's there. About to call it a night. Perhaps I'll have better luck in the morn.
Re: ECU pinout?
Fixed it for ya ;-) Yes, just like Jean says, in the docs directory called XDP512.....pinout.....ods or similar. I think I emailed you an xls copy too didn't I?jbelanger wrote:This is available in every firmware release (you know!) as a spreadsheet file in the docs directory.
Fred.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
Re: ECU pinout?
So I found what I was talking out here
http://www.diyefi.org/forum/viewtopic.php?f=9&t=336
Looks like it's a partical snap shot, however. So I guess I'm going to have to install open-office.
http://www.diyefi.org/forum/viewtopic.php?f=9&t=336
Looks like it's a partical snap shot, however. So I guess I'm going to have to install open-office.