The other night I took a photo of this Lantis ECU in its natural home: https://twitter.com/FredCookeNZ/status/ ... 0786345984
More progress tonight. 13B Matt was around playing with his Jaguar setup and preparing it for barp barp barp seals rotary action. So I hacked on the LH2.4 stuff :-)
Connector removed and ready for reuse: https://twitter.com/FredCookeNZ/status/ ... 8732030976
Bosch's Spain branch forgot to finish the box: https://twitter.com/FredCookeNZ/status/ ... 2658516992
Jaguar with heaps of room to play with: https://twitter.com/FredCookeNZ/status/ ... 1624738816
EDIT: 3.1mm is the diameter of the rivets that held the connector and heatsink to the PCB. M3 screws would be a good replacement, or a pop rivet, perhaps. Factory ones were, of course, pressed into place.
Matthijs309: Link the pics of your Jaguar holding device? And if you recall where, link Rob's Jaguar holding device? I will need something similar for this setup.
Ignition box hacking next week. Busy week this week with work, hospital visits, Volvo parts obtaining, Millenia parts stripping, garage cleaning, etc.
- where Open Source means Open Source, and Free means FreedomFreeEMS.org
- the open source engine management systemFreeEMS dev diary
and its comments thread
and my turbo truck!n00bs
, do NOT
PM or email tech questions! Use the forum!The ever growing list of FreeEMS success stories!