The other night I took a photo of this Lantis ECU in its natural home:
https://twitter.com/FredCookeNZ/status/ ... 0786345984More progress tonight. 13B Matt was around playing with his Jaguar setup and preparing it for barp barp barp seals rotary action. So I hacked on the LH2.4 stuff :-)
Connector removed and ready for reuse:
https://twitter.com/FredCookeNZ/status/ ... 8732030976Bosch's Spain branch forgot to finish the box:
https://twitter.com/FredCookeNZ/status/ ... 2658516992Jaguar with heaps of room to play with:
https://twitter.com/FredCookeNZ/status/ ... 1624738816EDIT: 3.1mm is the diameter of the rivets that held the connector and heatsink to the PCB. M3 screws would be a good replacement, or a pop rivet, perhaps. Factory ones were, of course, pressed into place.
Matthijs309: Link the pics of your Jaguar holding device? And if you recall where, link Rob's Jaguar holding device? I will need something similar for this setup.
Ignition box hacking next week. Busy week this week with work, hospital visits, Volvo parts obtaining, Millenia parts stripping, garage cleaning, etc.
_________________DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and
its comments thread and
my turbo truck!n00bs, do
NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!