Page 1 of 1
Freeems on 2-stroke ?
Posted: Sat Sep 06, 2014 1:13 pm
by bojane
I have succesfully built a 3 cyl 2-stroke using a ms3.
Some specs:
6 injectors
Dual fuelpumps
PID controlling wastegate to turbo.
Cop
Maf (frequensy based)
Now my question, is it possible to use freeems doing a simillar setup with a 2-stroke ?
Regards
Anders
Re: Freeems on 2-stroke ?
Posted: Mon Sep 08, 2014 9:37 pm
by molak
turboed 2 stroke?
Re: Freeems on 2-stroke ?
Posted: Tue Sep 09, 2014 3:16 am
by Hentai
molak wrote:turboed 2 stroke?
nothing new, its been done before.
As of now there is no maf support
Re: Freeems on 2-stroke ?
Posted: Tue Sep 09, 2014 9:39 am
by Fred
bojane wrote:Now my question, is it possible to use freeems doing a simillar setup with a 2-stroke ?
Similar, yes, same, no.
bojane wrote:6 injectors without ignition, or in batch modes, 3 would be better for the time being
Dual fuelpumps can use gpio to control the second one
PID controlling wastegate to turbo. sooner or later, we have PID, but it's rudimentary, and I need this feature for my truck too
Cop Yes with 3 injectors, or batch injection
Maf (frequensy based) MAF yes (existing impl or a new better impl), frequency no.
Hentai wrote:As of now there is no maf support
False! It's been in there since the beginning. Though I'll give you that it probably sucks and has never been used, and won't have frequency support for a long time.
Re: Freeems on 2-stroke ?
Posted: Tue Sep 09, 2014 6:39 pm
by bojane
bojane wrote:
6 injectors without ignition, or in batch modes, 3 would be better for the time being
Dual fuelpumps can use gpio to control the second one
PID controlling wastegate to turbo. sooner or later, we have PID, but it's rudimentary, and I need this feature for my truck too
Cop Yes with 3 injectors, or batch injection
Maf (frequensy based) MAF yes (existing impl or a new better impl), frequency no.
OK, is there some sort of roadmap what features you are working on ? And when they will be released ?
Is it possible to use 2 extra GPIO PID controllers (controlling the fuelpumps) ?
Turbo 2 stroke with MS3 was not easy to get going, learned tons of stuff
Will hopefully go easier the second time ......
Re: Freeems on 2-stroke ?
Posted: Wed Sep 17, 2014 6:11 am
by molak
Hentai wrote:molak wrote:turboed 2 stroke?
nothing new, its been done before.
As of now there is no maf support
I have seen a couple and so far no one really works ...