I have succesfully built a 3 cyl 2-stroke using a ms3.
Some specs:
6 injectors
Dual fuelpumps
PID controlling wastegate to turbo.
Cop
Maf (frequensy based)
Now my question, is it possible to use freeems doing a simillar setup with a 2-stroke ?
Regards
Anders
Freeems on 2-stroke ?
Re: Freeems on 2-stroke ?
turboed 2 stroke?
Re: Freeems on 2-stroke ?
nothing new, its been done before.molak wrote:turboed 2 stroke?
As of now there is no maf support
Re: Freeems on 2-stroke ?
Similar, yes, same, no.bojane wrote:Now my question, is it possible to use freeems doing a simillar setup with a 2-stroke ?
bojane wrote:6 injectors without ignition, or in batch modes, 3 would be better for the time being
Dual fuelpumps can use gpio to control the second one
PID controlling wastegate to turbo. sooner or later, we have PID, but it's rudimentary, and I need this feature for my truck too
Cop Yes with 3 injectors, or batch injection
Maf (frequensy based) MAF yes (existing impl or a new better impl), frequency no.
False! It's been in there since the beginning. Though I'll give you that it probably sucks and has never been used, and won't have frequency support for a long time.Hentai wrote:As of now there is no maf support
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
Re: Freeems on 2-stroke ?
OK, is there some sort of roadmap what features you are working on ? And when they will be released ?bojane wrote:
6 injectors without ignition, or in batch modes, 3 would be better for the time being
Dual fuelpumps can use gpio to control the second one
PID controlling wastegate to turbo. sooner or later, we have PID, but it's rudimentary, and I need this feature for my truck too
Cop Yes with 3 injectors, or batch injection
Maf (frequensy based) MAF yes (existing impl or a new better impl), frequency no.
Is it possible to use 2 extra GPIO PID controllers (controlling the fuelpumps) ?
Turbo 2 stroke with MS3 was not easy to get going, learned tons of stuff Will hopefully go easier the second time ......
Re: Freeems on 2-stroke ?
Hentai wrote:nothing new, its been done before.molak wrote:turboed 2 stroke?
As of now there is no maf support
I have seen a couple and so far no one really works ...