FreeEMS port on different CPU-AVR,ARM?
Posted: Tue Nov 22, 2011 12:44 pm
Hi all.
This is my first post, I'm sorry if I wrote in the wrong section.
I'm trying to build an electronic injection to my one cylinder motorcycle. FreeEMS I really liked because of the nice, well-documented code. I appreciate also that for this project is already no small community. Unfortunately, I have absolutely no experience with Freescale processors.
However, for the time being does not use XGATE, so the code should allow the move to other platform. I thought to myself, to try to carry out the code on the AVR or ARM, and build their own hardware layer.
I'm afraid, however, that it might be too difficult a task. I would like to start from as little-developed program (possibly from a very early version of FreeEMS). I would be grateful for your help in indicating to me the way how to go about it. I also want to ask where I could ask on the forum on the problems that I will be encountering.
I need only one or two (for two intake ports) injectors and spark one channel and use cheaper narrowband probe (PID mode). I wish that my project was the cheapest, at least at the beginning.
I have experience in programming AVR, low in the ARM. I wrote to the author FreeECU-I think that can help me. I think, to probe deeper into the code SECU-3 - timing procedures may be good enough to simply use it to add injection.
I think that such a project could be useful for many people.
And what you think about that?
This is my first post, I'm sorry if I wrote in the wrong section.
I'm trying to build an electronic injection to my one cylinder motorcycle. FreeEMS I really liked because of the nice, well-documented code. I appreciate also that for this project is already no small community. Unfortunately, I have absolutely no experience with Freescale processors.
However, for the time being does not use XGATE, so the code should allow the move to other platform. I thought to myself, to try to carry out the code on the AVR or ARM, and build their own hardware layer.
I'm afraid, however, that it might be too difficult a task. I would like to start from as little-developed program (possibly from a very early version of FreeEMS). I would be grateful for your help in indicating to me the way how to go about it. I also want to ask where I could ask on the forum on the problems that I will be encountering.
I need only one or two (for two intake ports) injectors and spark one channel and use cheaper narrowband probe (PID mode). I wish that my project was the cheapest, at least at the beginning.
I have experience in programming AVR, low in the ARM. I wrote to the author FreeECU-I think that can help me. I think, to probe deeper into the code SECU-3 - timing procedures may be good enough to simply use it to add injection.
I think that such a project could be useful for many people.
And what you think about that?