DIYEFI.org Forum
http://forum.diyefi.org/

Neat Prototyping Board Design
http://forum.diyefi.org/viewtopic.php?f=37&t=1588
Page 1 of 1

Author:  Fred [ Mon Feb 13, 2012 12:49 pm ]
Post subject:  Neat Prototyping Board Design

Pretty cool!

http://www.elecfreaks.com/store/flower- ... p-378.html

Image

Someone should design one of these and do a shared run of them :-)

Fred.

Author:  Fred [ Wed Sep 04, 2013 12:35 am ]
Post subject:  Re: Neat Prototyping Board Design

Article on development of the above: http://www.elecfreaks.com/2362.html

Author:  Dan [ Wed Sep 04, 2013 7:03 am ]
Post subject:  Re: Neat Prototyping Board Design

yep, i would like to do a shared run.

Will be a piece of piss to knock it up in Altium!

Who is keen for one/some/lots ?

Author:  Fred [ Wed Sep 04, 2013 12:07 pm ]
Post subject:  Re: Neat Prototyping Board Design

Me. Unsure when, not soon, but early next year I'd love to have some (several) laying around.

Would you just cover the entire surface in them edge to edge? Or? Why?

Which size break? Seeed 100x100 or 200x100 are most cost effective IIRC.

Fred.

Author:  Dan [ Wed Sep 04, 2013 1:15 pm ]
Post subject:  Re: Neat Prototyping Board Design

Probably 200x100 I would think. Rectangular seems to be a good size as opposed to square.

I would do them over the entire surface mostly, with a thin border for neatness.

Probably chuck in some 4mm diameter holes in each corner too :-)

Author:  Fred [ Wed Sep 04, 2013 2:01 pm ]
Post subject:  Re: Neat Prototyping Board Design

Sounds fair! Make it happen. I look forward to seeing high-res photos of them on your desk and cloning the Git repo.

Author:  Dan [ Wed Sep 04, 2013 9:35 pm ]
Post subject:  Re: Neat Prototyping Board Design

:-)

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/