Page 1 of 1
Neat Prototyping Board Design
Posted: Mon Feb 13, 2012 12:49 pm
by Fred
Pretty cool!
http://www.elecfreaks.com/store/flower- ... p-378.html
Someone should design one of these and do a shared run of them :-)
Fred.
Re: Neat Prototyping Board Design
Posted: Wed Sep 04, 2013 12:35 am
by Fred
Article on development of the above:
http://www.elecfreaks.com/2362.html
Re: Neat Prototyping Board Design
Posted: Wed Sep 04, 2013 7:03 am
by Dan
yep, i would like to do a shared run.
Will be a piece of piss to knock it up in Altium!
Who is keen for one/some/lots ?
Re: Neat Prototyping Board Design
Posted: Wed Sep 04, 2013 12:07 pm
by Fred
Me. Unsure when, not soon, but early next year I'd love to have some (several) laying around.
Would you just cover the entire surface in them edge to edge? Or? Why?
Which size break? Seeed 100x100 or 200x100 are most cost effective IIRC.
Fred.
Re: Neat Prototyping Board Design
Posted: Wed Sep 04, 2013 1:15 pm
by Dan
Probably 200x100 I would think. Rectangular seems to be a good size as opposed to square.
I would do them over the entire surface mostly, with a thin border for neatness.
Probably chuck in some 4mm diameter holes in each corner too
Re: Neat Prototyping Board Design
Posted: Wed Sep 04, 2013 2:01 pm
by Fred
Sounds fair! Make it happen. I look forward to seeing high-res photos of them on your desk and cloning the Git repo.
Re: Neat Prototyping Board Design
Posted: Wed Sep 04, 2013 9:35 pm
by Dan