 |
 |
 |
|
Page 1 of 1
|
[ 2 posts ] |
|
Author |
Message |
whizzo944
QFP80 - Contributor
Joined: Sun Mar 27, 2011 9:35 am Posts: 53 Location: Durham, U.K.
|
Hello All, I can't get FreeTherm 0.6 to run under Win7 x64, but FreeTherm 0.5 runs I installed the needed files for GTK and GTK# and Mono My questions are :- What settings do I use in FreeTherm 0.5 ? How do I decide the optimum bias resistor ?
TIA,
Dave.
|
Mon Jul 14, 2014 6:02 pm |
|
 |
Fred
Moderator
Joined: Tue Jan 15, 2008 2:31 pm Posts: 15377 Location: Home sweet home!
|
IIRC, you need to be running anew unreleased version for some reason.
However, unless you have a nonstandard sensor, you don't need to use it at all.
Choosing a bias resistor comes down to a compromise between accuracy in one place and accuracy in another.
Settings wise, you just need the curve for your sensor(s), and some knowledge of the firmware structure to use the output.
_________________DIYEFI.org - where Open Source means Open Source, and Free means Freedom FreeEMS.org - the open source engine management system FreeEMS dev diary and its comments thread and my turbo truck!n00bs, do NOT PM or email tech questions! Use the forum! The ever growing list of FreeEMS success stories!
|
Mon Jul 14, 2014 8:09 pm |
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 1 guest |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|
 |
|