Finally got the garage cleared up behind the BMW carcass. Volvo engine fully stripped and relocated. Most stuff put away where it belongs. So I was able to progress the BMW killing a little in preparation for more tomorrow! :-)
https://twitter.com/FredCookeNZ/status/ ... 3874807815
https://twitter.com/FredCookeNZ/status/ ... 9614942208
https://twitter.com/FredCookeNZ/status/ ... 5350779904
https://twitter.com/FredCookeNZ/status/ ... 6584313856
https://twitter.com/FredCookeNZ/status/ ... 3190804481
https://twitter.com/FredCookeNZ/status/ ... 4108272642
https://twitter.com/FredCookeNZ/status/ ... 5477880833
https://twitter.com/FredCookeNZ/status/ ... 6465700865
https://twitter.com/FredCookeNZ/status/ ... 2491659264
https://twitter.com/FredCookeNZ/status/ ... 1202308096
Tomorrow's plans, and the weekend's plans:
0) Remove 02 sensors from driver's side
0.5) Possibly be forced to remove driver's seat before 1
1) Cut other exhaust at the merge point
2) Remove all under-car plastic shields
3) Remove entire exhaust from merge backward
4) Wedge/jam front wheels so they can't roll
5) Remove fuel lines and/or tank after lifting body in the air
6) Disconnect brake lines from rear end
7) Disconnect anything else from the rear end
8) Lower entire rear subframe out of the shell
9) Remove seats from floor pan
10) Pull wiring forward and out of the way
11) Cut the rear off of the front
12) Cut rear into smaller pieces and put in the trailer for recycling
13) Find a place to put the rear subframe, diff, brakes, wheels, tyres, tank, etc.
14) Condense the remainder down until the KP60 can come home for repairs and WOF
Or something like that. Gotta get my KP back! :-)