Mercedes w124 coupe 300ce Start :)
Posted: Thu Jul 24, 2014 8:00 pm
Hello everyone!
I want to run my car on freeems
But I need some advice.
Poorly know English so I use the google translator - I'm sorry and ask for your understanding.
I want to run in this configuration:
6 cylinder engine - in sequence.
Wasted spark ignition
I guess I need 2x vr - 36-1 wheel and cam
I need a table switching 1xpb and 1xlpg and 2x ingnition pb / lpg.
I have 6 injectors PB 16ohm and 6 injectors LPG 2ohms (or insert P & H works with your processor?)
TPS Bosh 3 pin
MAP sensor
Air temperature sensor and water
tacho output
This is the first phase of my installation.
No one before had hid it in the MS3 but burned down.
In the next assembly step turbo.
So there is the boost control
It would be nice to be able to chip correction for the second dose of fuel maps after VE LPG temperature and pressure on the terminal injection.
That extra came to Map sensor and system of TEMPERATURE.
I have it at home or as part slice msv3 connecting the processor your input temperature map sensor, o2, tacho output will it work?
I want to run my car on freeems
But I need some advice.
Poorly know English so I use the google translator - I'm sorry and ask for your understanding.
I want to run in this configuration:
6 cylinder engine - in sequence.
Wasted spark ignition
I guess I need 2x vr - 36-1 wheel and cam
I need a table switching 1xpb and 1xlpg and 2x ingnition pb / lpg.
I have 6 injectors PB 16ohm and 6 injectors LPG 2ohms (or insert P & H works with your processor?)
TPS Bosh 3 pin
MAP sensor
Air temperature sensor and water
tacho output
This is the first phase of my installation.
No one before had hid it in the MS3 but burned down.
In the next assembly step turbo.
So there is the boost control
It would be nice to be able to chip correction for the second dose of fuel maps after VE LPG temperature and pressure on the terminal injection.
That extra came to Map sensor and system of TEMPERATURE.
I have it at home or as part slice msv3 connecting the processor your input temperature map sensor, o2, tacho output will it work?