WANTED: Ravage or Jaguar PCB

If you are looking to buy something, put the word about here.
Post Reply
Vitasik
TO220 - Visibile
Posts: 7
Joined: Tue May 15, 2012 7:50 pm

WANTED: Ravage or Jaguar PCB

Post by Vitasik »

Hi guys
I am starting to order bits and pieces for my little project.

To begin with I will be needing a PCB for either Ravage or Jaguar A3. it can be with parts or without. Preferably without. Where can I get one (or 2). And by get i ofcource mean buy.

Cheers
User avatar
Dan
LQFP144 - On Top Of The Game
Posts: 1204
Joined: Tue Mar 02, 2010 2:33 pm
Location: Australia

Re: WANTED: Ravage or Jaguar PCB

Post by Dan »

RavAGE is not a PCB, yet. But is very close to being one, pending some remaining testing that I and others need to conduct and compare/verify.

I would recommend Jaguar as it is a very well designed and tested hardware platform.

This obviously depends on what your requirements are though?

You can get the PCB artwork from the Jaguar GitHub repository or you can PM DeuceEFI on these forums and ask him if he has any Jaguar PCB's for sale.
malcom2073
LQFP112 - Up with the play
Posts: 211
Joined: Tue May 01, 2012 4:17 pm
Location: Shrewsbury PA
Contact:

Re: WANTED: Ravage or Jaguar PCB

Post by malcom2073 »

It would only cost something like $50 to get a Jaguar PCB made from batchpcb or something, might be the way to go.

You could also get 4 made from goldenphoenix for about $100 I believe.
User avatar
DeuceEFI
LQFP144 - On Top Of The Game
Posts: 578
Joined: Thu Feb 25, 2010 3:57 am
Location: Gosport, IN USA
Contact:

Re: WANTED: Ravage or Jaguar PCB

Post by DeuceEFI »

At this point unless you want to jump in feet first with a Jaguar A3 board from Kennybug, I would wait until I have all the changes done for the Jaguar A4 board which as quite a few refinements over the A3 boards.
Vitasik
TO220 - Visibile
Posts: 7
Joined: Tue May 15, 2012 7:50 pm

Re: WANTED: Ravage or Jaguar PCB

Post by Vitasik »

Ok - not a problem - I can wait, but it would be nice if you give me a rough estimate when Jaguar A4 will be around? I am watching progress report on A4 for quite some time and I am willing to wait for it if its going to come in .......lets say half a year.
User avatar
Dan
LQFP144 - On Top Of The Game
Posts: 1204
Joined: Tue Mar 02, 2010 2:33 pm
Location: Australia

Re: WANTED: Ravage or Jaguar PCB

Post by Dan »

Andy is working pretty much on it daily, so it would be a safe assumption (i think) that A4 would be ready within the next 6 months.

RavAGE spin 1 will likely be released within that timeframe too! :-)
Post Reply