Page 1 of 1
Frankenso for rusEfi: kits or assembled
Posted: Tue Dec 30, 2014 3:45 pm
by russian
bare PCB for rusEfi to be used with an old 64 Mazda ECU case. These four layer boards are larger then the two layer
Frankenstein boards, with these one has an option to solder an stm32f4 chip right on the board.
$39
Re: Frankenso for rusEfi: kits or assembled
Posted: Tue Dec 30, 2014 3:47 pm
by russian
Also available as a kit with the connector and all the I/O chips
$90
x1 Frankenso board
x12 low-side VNS14NV04
x3 op-amp LMV324IDT
x3 high-side TC4427
x2 2x25 header
x2 SD card socket
x1 VR INTERFACE MAX9926
x1 CAN interface SN65HVD230
x2 33uH Inductor
x2 CAP TANT 220UF
x1 IC REG BUCK 5V 3A
x1 CAP ALUM 680UF
x4 misc diodes for power supply
x1 HIP9011 knock detection chip
x1 4MHz osc for HIP9011
Re: Frankenso for rusEfi: kits or assembled
Posted: Sun Jan 25, 2015 1:52 am
by russian
Re: Frankenso for rusEfi: kits or assembled
Posted: Sun Jan 25, 2015 4:44 am
by Nige
Interesting... is that the same ECU connector as 90's Mitsubishi/Toyota? Denso OEM ECU case?
Re: Frankenso for rusEfi: kits or assembled
Posted: Sun Jan 25, 2015 4:47 am
by russian
Yes, same 64 pin connector as 90's Mitsubishi/Toyota/Honda/Mazda. Yep, Denso OEM case from a Mazda 323/Protege/Miata.
Re: Frankenso for rusEfi: kits or assembled
Posted: Tue Nov 17, 2015 1:54 am
by russian
Second batch of assembled version 0.4 has arrived. Note larger proto area and two extra low current drivers.
Re: Frankenso for rusEfi: kits or assembled
Posted: Sat Feb 25, 2017 4:40 am
by russian
New batch of same exact Frankenso 0.4 has arrived - boards are back in stock.
https://www.tindie.com/products/russian ... ll-bundle/
Re: Frankenso for rusEfi: kits or assembled
Posted: Mon Jan 15, 2018 10:34 pm
by russian
