DIYEFI.org Forum
http://forum.diyefi.org/

Frankenso for rusEfi: kits or assembled
http://forum.diyefi.org/viewtopic.php?f=27&t=2544
Page 1 of 1

Author:  russian [ Tue Dec 30, 2014 3:45 pm ]
Post subject:  Frankenso for rusEfi: kits or assembled

bare PCB for rusEfi to be used with an old 64 Mazda ECU case. These four layer boards are larger then the two layer Frankenstein boards, with these one has an option to solder an stm32f4 chip right on the board.

Image

$39

Author:  russian [ Tue Dec 30, 2014 3:47 pm ]
Post subject:  Re: Frankenso for rusEfi: kits or assembled

Also available as a kit with the connector and all the I/O chips

Image

$90

x1 Frankenso board
x12 low-side VNS14NV04
x3 op-amp LMV324IDT
x3 high-side TC4427
x2 2x25 header
x2 SD card socket
x1 VR INTERFACE MAX9926
x1 CAN interface SN65HVD230
x2 33uH Inductor
x2 CAP TANT 220UF
x1 IC REG BUCK 5V 3A
x1 CAP ALUM 680UF
x4 misc diodes for power supply
x1 HIP9011 knock detection chip
x1 4MHz osc for HIP9011

Author:  russian [ Sun Jan 25, 2015 1:52 am ]
Post subject:  Re: Frankenso for rusEfi: kits or assembled

Have two fully assembled boards

Image
https://www.tindie.com/products/russian/frankenso-01-assembled/

Image
https://www.tindie.com/products/russian/frankenso-01-full-bundle/

Author:  Nige [ Sun Jan 25, 2015 4:44 am ]
Post subject:  Re: Frankenso for rusEfi: kits or assembled

Interesting... is that the same ECU connector as 90's Mitsubishi/Toyota? Denso OEM ECU case?

Author:  russian [ Sun Jan 25, 2015 4:47 am ]
Post subject:  Re: Frankenso for rusEfi: kits or assembled

Yes, same 64 pin connector as 90's Mitsubishi/Toyota/Honda/Mazda. Yep, Denso OEM case from a Mazda 323/Protege/Miata.

Author:  russian [ Tue Nov 17, 2015 1:54 am ]
Post subject:  Re: Frankenso for rusEfi: kits or assembled

Second batch of assembled version 0.4 has arrived. Note larger proto area and two extra low current drivers.

Attachments:
IMAG1600%5B1%5D.jpg
IMAG1600%5B1%5D.jpg [ 1.7 MiB | Viewed 6576 times ]

Author:  russian [ Sat Feb 25, 2017 4:40 am ]
Post subject:  Re: Frankenso for rusEfi: kits or assembled

New batch of same exact Frankenso 0.4 has arrived - boards are back in stock.

https://www.tindie.com/products/russian ... ll-bundle/

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/