Page 7 of 8

Re: Jaguar 0.7-alpha kits For Sale

Posted: Thu Oct 09, 2014 12:19 pm
by reanimotion
Arrived today.
Thanks Andy!

Re: Jaguar 0.7-alpha kits For Sale

Posted: Sat Jul 11, 2015 6:01 am
by reanimotion
Serial #33 donated to FreeEMS community

Re: Jaguar 0.7-alpha kits For Sale

Posted: Sat Jul 11, 2015 7:05 am
by Fred
reanimotion wrote:Serial #33 donated to FreeEMS community
I speak for at least myself and the person in possession of it when I say: Thank you very much! <3

It could run an engine tomorrow, or if not, any day now, and an epic and infamous engine at that! :-D

Re: Jaguar 0.7-alpha kits For Sale

Posted: Sat Aug 22, 2015 12:19 am
by AldoQ
Hi
i want 1 bare pcb and bdm
regrds

Re: Jaguar 0.7-alpha kits For Sale

Posted: Sun Aug 23, 2015 3:02 am
by DeuceEFI
AldoQ wrote:Hi
i want 1 bare pcb and bdm
regrds
PM sent to AldoQ with cost and shipping information request.

Re: Jaguar 0.7-alpha kits For Sale

Posted: Thu Feb 08, 2018 9:14 pm
by EFIRick
what is the status of new boards/kits?

Re: Jaguar 0.7-alpha kits For Sale

Posted: Sat Feb 10, 2018 3:42 pm
by DeuceEFI
I worked on the design for Jaguar v0.8, which has a few improvements over the v0.7, a while ago. I just haven’t finished the design since I was waiting to see if there were any further refinements to make to the design.

I just recently sold the last of the v0.7 boards so it might be time for a new run of boards. :-)

I do have CoolEFI Basic ECU v0.2-alpha fully assembled boards in stock which is based on the Jaguar schematics and has many of the capabilities of the Jaguar PCB along with a simple Molex connector. I was designed for 4 cylinder engines and has run my 2.2L Chevrolet S10 with FreeEMS using the same firmware that was build for the Jaguar v0.7-alpha that was previously in the S10. The Basic ECU can be found at http://www.coolefi.com.

If there is interest in a Jaguar v0.8 then I will invest some time and money to finish the design and have another run of PCBs manufactured.

Re: Jaguar 0.7-alpha kits For Sale

Posted: Sat Feb 10, 2018 7:11 pm
by EFIRick
If I purchased a FreeEMS board it would need to be V8 compatible, so that leaves off the CoolEFI board.

I also may need a trans controller for this project if I proceed

It would be housed in a OEM case PNP style so I can switch back to OBD2 for emissions compliance testing. 04 Dakota w/Daimler V8

Re: Jaguar 0.7-alpha kits For Sale

Posted: Sat Feb 10, 2018 7:23 pm
by Matthijs
If it helps you to cover some costs I will take one or two pcbs

Re: Jaguar 0.7-alpha kits For Sale

Posted: Sat Feb 10, 2018 11:48 pm
by EFIRick
What has changed in the 0.8 board?