DIYEFI.org Forum

DeuceEFI wrote:I can report the new high side driver is working properly to control the factory fuel pump relay.

Great news! :-)

Hello,
Have I missed the boat on this ? If not, I am interested in an Option #3 board only, with either 115kPa or 250kPa sensor, and
shipping to the UK.

Thanks,

Dave.

Is your build NA or boosted? Boosted below 21psi? Planning boost later? Gotta choose, can't make Andy choose for ya :-)

Normally Aspirated, it's my bike project.

TIA

Dave.

Highest resolution or most future proof for other projects? :-) The default is 250kPa but if it's 100% never going to see a boosted vehicle, 115kPa is slightly superior.

115kPa please

Thanks,

Dave.

whizzo944 wrote:115kPa please

Thanks,

Dave.

OK, cool, I have you down for an Option #3 with 115kPa MAP sensor. You have a PM for the total with the shipping cost.

Cheers,

Do you have an ETA for the new Jaguar boards? Yes, I am very impatient but I am at a stage with my project bike where i want to start and run
the engine and, if the ETA is not too far off, I can go straight to FreeEMS. Otherwise I will have to use my MS2

TIA,

Dave.

UPDATE:
I will start shipping the Option #1 boards and the Option #2 kits this week, but keep in mind that Friday, July 4th is a holiday in the USA.

Option #3 (SMD Soldered) kits will ship out by July 18th and the Option #4 (assembled) boards will be shipped out after they have been built and bench tested. The Option #4 will take a little longer due to the assembly time, but they should all be shipped by July 25th.

Thanks Andy,

Dave.