DIYEFI.org Forum

One option is I can take one these dust 0.4 fully build version, if price would be reasonable.
Can take to bench testing and later put on one aircooled car possible which has Edis ignition and old own M$1 design board.
There was one rerouting and other changes are minor for comparing to for this new 0.6 version? That I looked fast.

I don't think there is much point to moving around old boards, mostly. Everyone should be aiming to use new boards. Old boards should be used by who bought them, or put on a shelf as a souvenir IMO.

That's true. I'll wait brand new version then

Fred wrote:OK, so you want in on first 10 then, and are happy to take that risk? Or second batch only if first is good? Or third batch if second is bad? Or? Will move you when I fully understand.

Please put me on top of the list of the batch that will be run after the first 10 have been tested.
I don't feel that comfortable with soldering for being a guinea pig - I'll be happy to take the risk of the batch that is spun following the first 10 boards.
Really do want to get started

walinsky wrote:Please put me on top of the list of the batch that will be run after the first 10 have been tested.

Moved to main list, which I'll have to push you out of again if the first lot are rugged. Or the whole group can fund the wasted boards if there are issues. Or something.

Ooh order day! Who do I send the cash-ish too? paypal ok? I couldnt find the 0.6 BOM in the docs either... want to pre order the materials for build day.

When it's time to order, these things will be published in a new thread. BOM will be similar to 0.4 but different. You'll have to wait and see if you want an accurate one-shot order.

See viewtopic.php?p=38399#p38399 to order a Jaguar 0.7-alpha PCB/kit.