DIYEFI.org Forum

I have two (2) remaining Jaguar A3 boards left, I can supply you with the following configuration for $82 USD each plus shipping from Indiana, USA:

Jaguar A3 PCB,
MCU with the Serial Monitor loaded,
MAX9926,
FTDI USB UART,
up to six (6) Injector drivers
both the Fuel Pump/Fan drivers.

This will be a functional MCU/all silicon components board with the capabilities of a TA board, including already having the Serial Monitor program loaded so you can use the Load/Run jumper. You will need to supply the passive components as found in my BOM at https://github.com/DeuceEFI/Jaguar/blob ... Jaguar.ods in order to use the board (you will need to supply the remainder of the components yourself).

Complete Jaguar FreeEMS forum section: viewforum.php?f=67

Supported Injection methods: viewtopic.php?f=67&t=1543

Supported Ignition systems: viewtopic.php?f=67&t=1541

Instructions on how to build the Jaguar A3 PCB: https://github.com/DeuceEFI/Jaguar-Assembly-Manual

And finally a link to videos of the Jaguar A3 board in action on a GM 3.1L V6: viewtopic.php?f=67&t=1627

[Edit 10-13-2012] Both Jaguar A3 boards have been sold and shipped, congratulations malcom2073 and ToxicGumbo!

For reference, I've just contacted DeuceEFI for a board.

-Jeff

So far masterkorp and ToxicGumbo have expressed interest in purchasing the 2 Jaguar A3 boards.

If either of them decides not to take it, I'll take one.