Where is all this stuff?
I am not a hardware builder - can I use existing "cheaper" hardware?
I just want a topnotch ignition controller for a special V-twin project. Is this suitable?
(similar to a good car one: knock sensing, remapping etc)
Should I use Holley smart coils, or a power box? I want to run 3 plugs per cylinder.
What is a good alternative coil to use?
How do I run 3 coils in parallel, firing at the same time? Is it similar to a wasted spark setup?
I am also not a fluent C programmer. How do I find out about user interfaces?
--
Owen_N
Location of extra FAQ, hardware/software scope docs etc...
Never mind. Finally found all sites, wiki,why etc
Looks like this is not really a user system yet.
I will head over to the megasquirt forum, and carry on there.
I will head over to the megasquirt forum, and carry on there.
Re: Location of extra FAQ, hardware/software scope docs etc.
Let us know if you change your mind and want some answers to the above. :-)
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!