 |
 |
 |
|
Page 1 of 1
|
[ 4 posts ] |
|
Bosch LSU4.2 with square connector
Author |
Message |
csracing
TO220 - Visibile
Joined: Mon Aug 17, 2015 3:22 pm Posts: 4
|
Hello,
I bought one of Alan To's WB controllers but am to the point where I've realized the connector on my WB sensor is different than what was supplied in the kit. I have a Bosch 17033 sensor from what I can tell and it uses a square 6-pin connector. The harness side uses a connector with a gray latch mechanism. Does anyone have the pinout information for this connection or a cross between this connection and the more conventional "D" shaped connectors that seem more common?
I've emailed Alan, but I haven't seen a reply yet. I'm in a bit of a rush as I am trying to get this done tomorrow (8/28) so any help appreciated.
CSR
|
Thu Aug 27, 2015 10:16 pm |
|
 |
Fred
Moderator
Joined: Tue Jan 15, 2008 2:31 pm Posts: 15376 Location: Home sweet home!
|
Apologies for the delay in authorising the post. Hopefully you got it sorted. There's only a few wires, so reverse engineering it shouldn't have been too hard in a total absence of online info.
_________________DIYEFI.org - where Open Source means Open Source, and Free means Freedom FreeEMS.org - the open source engine management system FreeEMS dev diary and its comments thread and my turbo truck!n00bs, do NOT PM or email tech questions! Use the forum! The ever growing list of FreeEMS success stories!
|
Sun Aug 30, 2015 1:43 am |
|
 |
csracing
TO220 - Visibile
Joined: Mon Aug 17, 2015 3:22 pm Posts: 4
|
I figured it out. The pinout is the same as the more conventional 'D' shaped connector.
I'm up and running.
|
Sun Aug 30, 2015 2:53 am |
|
 |
Fred
Moderator
Joined: Tue Jan 15, 2008 2:31 pm Posts: 15376 Location: Home sweet home!
|
_________________DIYEFI.org - where Open Source means Open Source, and Free means Freedom FreeEMS.org - the open source engine management system FreeEMS dev diary and its comments thread and my turbo truck!n00bs, do NOT PM or email tech questions! Use the forum! The ever growing list of FreeEMS success stories!
|
Sun Aug 30, 2015 6:59 am |
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 2 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|
 |
|