Secondary Igniton Voltage Reading via Arduino

Free and Open Source Engine Management discussions excluding more specific things on this board.
Post Reply
Delifisek
TO220 - Visibile
Posts: 8
Joined: Mon Sep 03, 2012 8:48 pm

Secondary Igniton Voltage Reading via Arduino

Post by Delifisek »

Hello again.

I hope, I do not disturb too much with my noob questions.

I had a device which can read Secondary Ignition Voltage and displays RPM.

http://www.gtc.ca/EN/TA100_EN.html

And it was very useful. It was hand held device and do not support for serial output. So I want to build this thing based on arduino to send this data to pc.

Is there any suggestion for sensors.

My Humble Regards.
User avatar
masterkorp
LQFP112 - Up with the play
Posts: 171
Joined: Tue Jan 17, 2012 11:21 am
Location: Ponte de Lima, Portugal

Re: Secondary Igniton Voltage Reading via Arduino

Post by masterkorp »

If you go forward with this, please keep us informed this is interesting
Delifisek
TO220 - Visibile
Posts: 8
Joined: Mon Sep 03, 2012 8:48 pm

Re: Secondary Igniton Voltage Reading via Arduino

Post by Delifisek »

I'm trying o forward. And it was hard. Due to lack of electronic knowladge plus, finding parts in my country slow down my effort. And I will not surrender.

Anyhow.

I found, that inductive clamp (which used for chineese ignition advance light) may useful. And I need voltage divider too.
Post Reply