Hello again.
I hope, I do not disturb too much with my noob questions.
I had a device which can read Secondary Ignition Voltage and displays RPM.
http://www.gtc.ca/EN/TA100_EN.html
And it was very useful. It was hand held device and do not support for serial output. So I want to build this thing based on arduino to send this data to pc.
Is there any suggestion for sensors.
My Humble Regards.
Secondary Igniton Voltage Reading via Arduino
- masterkorp
- LQFP112 - Up with the play
- Posts: 171
- Joined: Tue Jan 17, 2012 11:21 am
- Location: Ponte de Lima, Portugal
Re: Secondary Igniton Voltage Reading via Arduino
If you go forward with this, please keep us informed this is interesting
Re: Secondary Igniton Voltage Reading via Arduino
I'm trying o forward. And it was hard. Due to lack of electronic knowladge plus, finding parts in my country slow down my effort. And I will not surrender.
Anyhow.
I found, that inductive clamp (which used for chineese ignition advance light) may useful. And I need voltage divider too.
Anyhow.
I found, that inductive clamp (which used for chineese ignition advance light) may useful. And I need voltage divider too.